Puddle Lights Guides

  1. Open the left front door and fully lower the left front window.
  2. Carefully use a small screwdriver or the pry tool to pry the puddle light out of the bottom of the left front door panel.
  3. Press down on the locking tab to disconnect the puddle light connector and then remove the light from the vehicle. CAUTION Do not pull the puddle lamp too far from the door panel, as the puddle lamp connector is still attached.
  4. Connect the electrical wiring harness to the ModelMate Puddle Light. Check to ensure puddle lights up.
    NOTE
    Once connected correctly, the Tesla Projection Light will turn on and display the Tesla logo.
  5. After connecting the electrical wiring harness to the Tesla Puddle Light, ensure the “Tesla” logo correctly projects on the floor before securing the Projection Light in place.
  6. Insert the ModelMate Puddle Light in the opening at the bottom of the door panel. Press upward firmly to ensure the Tesla Projection Light snaps securely into the door panel.
  7. Raise the left front window and close the left front door.
  8. Perform this procedure again on the other 3 doors.